The Spinner by William-Adolphe Bouguereau shows a woman hand-spinning using a drop spindle. Fibers to be spun are bound to a distaff.

Characteristics of spun yarn vary based on the material used, fiber length and alignment, quantity of fiber used, and degree of twist.

History

Hand spinning

1905 illustration of a Tibetan spinning wool.

Irreler Bauerntradition shows carding, spinning and knitting in the Roscheider Hof, Open Air Museum

The next method of twisting yarn was with the spindle, a straight stick eight to twelve inches long on which the thread was wound after twisting. At first it had a cleft or split in the top in which the thread was fixed; later a hook of bone was added to the upper end. The bunch of wool or plant fibers is held in the left hand; with the right hand the fibers are drawn out several inches and the end fastened securely in the slit or hook on the top of the spindle. A whirling motion is given to the spindle on the thigh or any convenient part of the body; the spindle is then dropped, twisting the yarn, which is wound on the upper part of the spindle. Another bunch of fibers is drawn out, the spindle is given another twirl, the yarn is wound on the spindle, and so on.^[2]

The distaff was used for holding the bunch of wool, flax, or other fibers. It was a short stick on one end of which was loosely wound the raw material. The other end of the distaff was held in the hand, under the arm or thrust in the girdle of the spinner. When held thus, one hand was left free for drawing out the fibers.^[2]

A spindle containing a quantity of yarn rotates more easily, steadily and continues longer than an empty one, hence the next improvement was the addition of a weight called a spindle whorl at the bottom of the spindle. These whorls are discs of wood, stone, clay, or metal with a hole in the center for the spindle, which keep the spindle steady and promote its rotation. Spindle whorls appeared in the Neolithic era.^[2].^[3]

Industrial spinning

A mule spinning machine at Quarry Bank Mill, UK.

The spinning jenny, a multi-spool spinning wheel invented circa 1764 by James Hargreaves, dramatically reduced the amount of work needed to produce yarn, with a single worker able to work eight or more spools at once. At roughly the same time, Richard Arkwright and a team of craftsmen developed the spinning frame, which produced a stronger thread than the spinning jenny. Too large to be operated by hand, a spinning frame powered by a waterwheel became the water frame.

In 1779, Samuel Crompton combined elements of the spinning jenny and water frame to create the spinning mule. This produced a stronger thread, and was suitable for mechanisation on a grand scale.

In the 20th century, new techniques including Open End spinning or rotor spinning were invented to produce yarns at rates in excess of 40 meters per second.

Characteristics of spun yarns

Materials

Yarn can be, and is, spun from a wide variety of materials, including natural fibers such as animal, plant, and mineral fibers, and synthetic fibers. It was probably first made from plant fibers, but animal fibers soon followed.

Twist and ply

Z-twist and S-twist yarns

Two or more spun yarns may be twisted together or plied to form a thicker yarn. Generally, handspun single plies are spun with a Z-twist, and plying is done with an S-twist.^[5]

Plying methods

Yarns can be made of two, three, four, or more plies, or may be used as singles without plying. Two-ply yarn can also be plied from both ends of one long strand of singles using Andean plying, in which the single is first wound around one hand in a specific manner that allows unwinding both ends at once without tangling. Navajo plying is another method of producing a three-ply yarn, in which one strand of singles is looped around itself in a manner similar to crochet and the resulting three parallel strands twisted together. This method is often used to keep colors together on singles dyed in sequential colors. Cabled yarns are usually four-ply yarns made by plying two strands of two-ply yarn together in the direction opposite to the plying direction for the two-ply yarns.

Contemporary hand spinning

An Indian charka in action

Within the recent past, many new spinners have joined into this ancient process, innovating the craft and creating new techniques. From using many new applications of dyeing before spinning, to mixing in random elements (Christmas Garland, eccentric beads, money, etc.) that would not be in a traditional yarn, to creating new techniques like coiling^[6], this craft is constantly evolving and shifting.

Reine Berthe instructing girls to spin flax on spindles using distaffs

The fiber can be dyed at any time, but is often dyed before carding or after the yarn has been spun.

Wool may be spun before or after washing, although excessive amounts of lanolin may make spinning difficult, especially when using a drop-spindle. Careless washing may cause felting; when done prior to spinning this often leads to unusable wool fiber. In washing wool the key thing to avoid is too much agitation and fast temperature changes from hot to cold. Generally washing is done lock by lock in warm water with dish-soap.

Techniques

A handspinner using the short draw technique to spin wool.

Short draw spinning is used to create worsted yarns. It is spun from combed roving, sliver or wool top. The spinner keeps their hands very close to each other. The fibers are held, fanned out, in one hand, and the other hand pulls a small number from the mass. The twist is kept between the second hand and the wheel- there is never any twist between the two hands.

Long draw is spun from a carded rolag. The rolag is spun without much stretching of the fibers from the cylindrical configuration. This is done by allowing twist into a short section of the rolag, and then pulling back, without letting the rolag change position in your hands, until the yarn is the desired thickness. The twist will concentrate in the thinnest part of the roving, thus when the yarn is pulled, the thicker sections with less twist will tend to thin out. Once the yarn is the desired thickness, enough twist is added to make the yarn strong. Then the yarn is wound onto the bobbin, and the process starts again.

Spinning in the grease

Handspinners are split, when spinning wool, as to whether it is better to spin it 'in the grease' (with lanolin still in) or after it has been washed. More traditional spinners are more willing to spin in the grease, as it is less work to wash the wool after it is in yarn form. Spinners who spin very fine yarn may also prefer to spin in the grease as it can allow them to spin finer yarns with more ease. Spinning in the grease covers the spinner's hands in lanolin, and thus softens the spinner's hands.

Spinning in the grease only works really well if the fleece is newly sheared. After several months the lanolin becomes sticky, which makes it harder to spin using the short draw technique, and nigh impossible to spin using the long draw technique. In general, spinners using the long draw technique do not spin in the grease.

Spinners who don't spin in the grease generally buy their fibers pre-washed and carded, in the form of tow or roving. This means less work for the spinner, as they do not have to wash the lanolin out. It also means that one can spin predyed fiber, or blends of fibers, which are very hard to create when the wool is still in the grease. As machine carders cannot card wool in the grease, pre-carded yarn generally isn't spun in the grease. Some spinners, however, use spray on lanolin-like products to get the same feel of spinning in the grease with this carded fiber.

See also

• Cotton mill
• Crochet
• Distaff
• Knitting
• Loom
• Spinning jenny
• Weaving
• Spinning wheel
• Spindle (textiles)

Notes

References

This article contains text from the 1907 edition of Textiles and Clothing by Kate Heinz Watson, a document now in the public domain.

• Amos, Alden (2001). The Alden Amos Big Book of Handspinning, Loveland, Colorado: Interweave Press. ISBN 1883010888
• Barber, Elizabeth Wayland (1995). Women's Work: The First 20,000 Years: Women, Cloth, and Society in Early Times, W. W. Norton & Company, new edition, 1995.
• Boeger, Alexis (2005). Handspun Revolution, Pluckyfluff. ISBN 0976725207
• Jenkins, David, editor (2003). The Cambridge History of Western Textiles, Cambridge, UK: Cambridge University Press, ISBN 0521341078
• Piponnier, Françoise, and Perrine Mane (1997). Dress in the Middle Ages; Yale UP; ISBN 0300069065
• Ross, Mabel (1987). Essentials of Handspinning, Robin and Russ Handweavers. ISBN 0950729205
• Simmons, Paula (1982). Spinning for Softness and Speed, Seattle: Madrona. ISBN 0914842870
• Watson, Kate Heinz (1907). Textiles and Clothing, Chicago: Amercian School of Home Economics (online at ''Textiles and Clothing'' by Kate Heintz Watson).

External links

General

• Spinning Guilds Directory - An international list of spinning guilds
• Yarn Museum - Online gallery promoting handspun yarn.

Instructional Sites

• A complete spinning website - Learn about Blow room,carding,spinning, Fiber testing, Textile calculations etc
• Hampshire Spinning Guild - glossary of spinning terms, and pictures
• Joy of Hand Spinning - video instruction
• Spin-Off Magazine Spinning Basics - A list of PDF articles from the magazine on various spinning techniques.
• Navajo 3-ply Tutorial - plying video instruction
• Drop Spinning Instructions - step by step from carding to troubleshooting

de:Spinnen eo:?pinado gl:Fiar it:Filatura he:????? hu:Fonás nl:Spinnen (textiel) ja:?? pl:Prz?dzenie pt:Fiação ru:???????? fi:Kehräys sv:Spinning (textil)